5.4 System Control—System Shutdown
In order to turn off the power to a PBX, it must first be issued a shutdown command using Web Maintenance
Console. Follow the procedure below to prepare a PBX for system shutdown.
When the system is shut down, any settings not saved to the System Memory are lost. A backup should be
performed before the shutdown to ensure no data is lost. However, a backup should not be performed if
settings or data have recently been imported into the system, because performing a backup would overwrite
the imported data with the current PBX settings.
This screen can be accessed only in On-line mode.
1. Confirm the contents of the displayed warning message.
2. Click Backup or Skip according to the system's status:
• Backup: Click to backup system settings. The system will be reset after the backup has been
performed.
• Skip: The system is reset without performing a backup.
3. The STATUS LED on the front of the PBX will flash amber. When shutdown preparations are
completed, the STATUS LED will stop flashing and remain a solid amber. Once the STATUS LED stops
flashing, you may turn off the power switch on the back of the PBX.
5.4 System Control—System Shutdown
PC Programming Manual 71
To Next Page
Loading...
