Panasonic KX-NS300 - 11.1.3 PBX Configuration-[3-1-3] Group-Trunk Group-Caller ID Modification

Name Description
Value
Range
Links
Trunk
Group No.
& Name
Specifies the trunk group assigned
to the corresponding priority level.
Select the blank option to not
assign a trunk group to the priority.
Trunk Group
No. 1–64
PC Programming Manual
References
18.1 PBX Configuration—[10-1] CO
& Incoming Call—CO Line Settings
Feature Manual References
2.5.5.3 Trunk Access
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller
ID Modification
The telephone numbers of incoming callers can be modified automatically according to pre-programmed
modification tables, and then recorded for calling back.
Leading Digits
After the caller’s number is modified by the Length of Digits Modification Tables or CLIP Modification Tables,
the PBX checks the leading digits of the modified number for an area code programmed in the Caller ID
Modification Table assigned to that trunk group. If it finds such a code, it removes digits and adds a number
to the modified number. If this number is stored as a System Speed Dialling number, the caller’s name can
be shown on a PT display and the call can be routed to a certain extension (CLI destination). A maximum of
4 Caller ID Modification Tables, each containing 10 local/international call data and 1 long distance code,
can be programmed. Each trunk group can select a table for use. Select the desired table from the
Modification Table list.
If the modified number does not contain an area code programmed here, the PBX applies the Long
Distance Code settings to the modified number.
Name Description Value Range Links
Area Code (for
Local /
International Call
Data 1–10)
Specifies the leading
number (area code) to
look for in the incoming
caller’s number.
Max. 6 digits
(consisting of 0–
9, *, and #)
Feature Manual References
2.19.1 Caller ID
Removed
Number of Digits
Specifies the number of
digits to be removed
from the beginning of the
incoming caller’s
number.
0–9
PC Programming Manual
References
11.1.1 PBX Configuration—[3-1-1]
Group—Trunk Group—TRG Settings
—Caller ID Modification Table
14.1 PBX Configuration—[6-1]
Feature—System Speed Dial
Feature Manual References
2.19.1 Caller ID
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
384 PC Programming Manual