Panasonic KX-NS300 - Page 385

Name Description Value Range Links
Added Number Specifies the number to
be added to the
incoming caller’s number
in the place of the
removed digits.
Max. 4 digits
(consisting of 0–
9, *, and #)
PC Programming Manual
References
11.1.1 PBX Configuration—[3-1-1]
Group—Trunk Group—TRG Settings
—Caller ID Modification Table
14.1 PBX Configuration—[6-1]
Feature—System Speed Dial
Feature Manual References
2.19.1 Caller ID
Length of Digits
The PBX adds a certain number of digits to the caller’s number depending on the length of digits, as
programmed in the Length of Digits Modification Tables assigned to the trunk group. This modification is
applied to incoming trunk calls routed through public networks when the type of network numbering plan is
Unknown or not specified.
A maximum of 4 Length of Digits Modification Tables can be programmed. Select the desired table from the
Modification Table list.
If the length of digits of an incoming trunk call is less than the Minimum Caller ID Digits (for National), the
caller’s number is not modified.
Name Description
Value
Range
Links
Minimum Caller
ID Digits (for
International)
Specifies the minimum number of digits
required in the caller’s number for it to be
recognised as an international call. The value
specified here must be larger than Minimum
Caller ID Digits (for National).
1–31
Feature Manual
References
2.19.1 Caller ID
Minimum Caller
ID Digits (for
National)
Specifies the minimum number of digits
required in the caller’s number for it to be
recognised as a national call. The value
specified here must be smaller than
Minimum Caller ID Digits (for
International).
0–30
Feature Manual
References
2.19.1 Caller ID
Added Number
(for International)
Specifies the number to be added to the
incoming telephone number when the total
number of digits exceeds Minimum Caller ID
Digits (for International).
Max. 8
digits (0–9,
*, and #)
Feature Manual
References
2.19.1 Caller ID
Added Number
(for National)
Specifies the number to be added to the
incoming telephone number when the total
number of digits exceeds Minimum Caller ID
Digits (for National) but does not exceed
Minimum Caller ID Digits (for
International).
Max. 8
digits (0–9,
*, and #)
Feature Manual
References
2.19.1 Caller ID
CLIP
When incoming caller information is sent through an ISDN line and the type of the network numbering plan
is International, National, or Subscriber, the caller’s number can be modified as programmed in the
Modification Tables assigned to the trunk group. The modified number will then be recorded, and it is used
for sending to the network as a CLIP number.
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
PC Programming Manual 385