Name Description Value Range Links
Use Quick Dial
for CO
rerouting during
"Break" Mode.
Specifies whether Quick Dialling
can be used to make a trunk call
via an extension registered at
another site in a One-look
network, when the Time Service
mode is Break mode.
On, Off
Feature Manual
References
2.6.5 Quick Dialling
5.1.4 Time Service
Use quick dial
for rerouting to
public CO when
TIE line does
not work.
Specifies whether Quick Dialling
can be used for rerouting to a
public trunk when a TIE line is
not operating.
On, Off
Feature Manual
References
2.6.5 Quick Dialling
Dial Specifies the Quick Dialling
number.
1–4000: Max. 8
digits (consisting of
0–9, *, and #)
Feature Manual
References
2.6.5 Quick Dialling
4.3.2 Voice over Internet
Protocol (VoIP) Network
5.5.7 Flexible Numbering/
Fixed Numbering
Phone Number Specifies the number to be
dialled when the corresponding
Quick Dialling number is used.
Max. 32 digits
(consisting of 0–9,
*, #, T [Transfer], [ ]
[Secret], P [Pause],
and F [Flash])
Feature Manual
References
2.6.5 Quick Dialling
4.3.2 Voice over Internet
Protocol (VoIP) Network
5.5.7 Flexible Numbering/
Fixed Numbering
10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—
B/NA DND Call Feature
Feature numbers used to access various PBX features can be programmed. The following features are
available while hearing a busy, DND, or ringback tone. Each feature must have a unique feature number.
For more information on flexible numbering, see "5.5.7 Flexible Numbering/Fixed Numbering" in the Feature
Manual.
10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—B/NA DND Call Feature
PC Programming Manual 345
To Next Page
Loading...
