10.3 PBX Configuration—[2-3] System—Timers &
Counters
Various system timers and counters can be programmed.
Dial / IRNA / Recall / Tone
Name Description
Value
Range
Links
Automatic Redial
—Repeat
Counter
Specifies the number of times
Automatic Redial is attempted before
being cancelled.
0–10
Feature Manual
References
2.6.3 Last Number Redial
Automatic Redial
—Repeat Interval
(x10s)
Specifies the length of time between
repeated Automatic Redial attempts.
10 × n
(n=1–120)
s
Feature Manual
References
2.6.3 Last Number Redial
Automatic Redial
—Redial Call
Ring Duration
(x10s)
Specifies the length of time that the
PBX waits for the called party to answer
an Automatic Redial attempt. This is the
length of time that the called party’s
extension will ring for each attempt.
10 × n
(n=1–30) s
Feature Manual
References
2.6.3 Last Number Redial
Automatic Redial
—Analogue CO
Mute / Busy
Detection Timer
(s)
Specifies the length of time before the
PBX stops muting the caller’s voice and
cancels busy tone detection when
Automatic Redial to analogue trunk is
performed.
0–15 s
Feature Manual
References
2.6.3 Last Number Redial
Dial—Hot Line
(Pickup Dial)
Start (s)
Specifies the length of time between
going off-hook and the start of automatic
dialling when the Hot Line feature is set.
0–180 s
Feature Manual
References
2.6.6 Hot Line
Dial—Extension
First Digit (s)
Specifies the length of time after going
off-hook within which the first digit of a
feature number or destination must be
dialled before a reorder tone is heard.
1–250 s
Feature Manual
References
2.5.2 Automatic Extension
Release
Dial—Extension
Inter-digit (s)
Specifies the length of time within which
subsequent digits must be dialled
before the PBX sends a reorder tone.
1–250 s
Feature Manual
References
2.5.2 Automatic Extension
Release
Dial—Analogue
CO First Digit (s)
Specifies the length of time within which
the first digit of a telephone number
must be sent to an analogue trunk. If no
digit is sent before this time expires, the
PBX recognises end of dialling and
stops muting the caller’s voice over the
analogue trunk.
1–15 s
10.3 PBX Configuration—[2-3] System—Timers & Counters
PC Programming Manual 315
To Next Page
Loading...
