Panasonic KX-NS300 - Page 531

Name Description Value Range Links
Network Data
Transmission for
Centralised
Operator Feature—
Data Transmission
ISDN->VoIP
Selects whether to re-send
BLF data received from an
ISDN port through any VoIP
ports that are set to transmit
BLF data.
Disable,
Enable
PC Programming Manual
References
17.3 PBX Configuration—[9-3]
Private Network—Network
Operator (VoIP)—IP-GW Card
Slot No. to notify BLF data to
Network Operator
Feature Manual
References
4.3.5.1 Network Direct Station
Selection (NDSS)
Network Data
Transmission for
Centralised
Operator Feature—
Data Transmission
Counter
Specifies the maximum
number of "hops", or
transmissions between two
PBXs, before a packet of BLF
data is discarded.
1–63
Feature Manual
References
4.3.5.1 Network Direct Station
Selection (NDSS)
Network Data
Transmission for
Centralised
Operator Feature—
Data Broadcasting
Interval Timer
Specifies the frequency of BLF
data transmission. The PBX
will send data over the network
periodically according to the
interval specified here.
100 × n (n=0–
30) ms
Feature Manual
References
4.3.5.1 Network Direct Station
Selection (NDSS)
Network MSW Data
Transmission for
Centralised VM
Feature—Data Re-
transmission :
Repeat Counter
Specifies the number of times
re-transmission of network
message waiting notifications
is repeated before being
cancelled.
0–10
PC Programming Manual
References
17.1 PBX Configuration—[9-1]
Private Network—TIE Table—
Enhanced QSIG Call
Information (Activation Key
Required)
Feature Manual
References
4.3.5.2 Centralised Voice Mail
Network MSW Data
Transmission for
Centralised VM
Feature—Data Re-
transmission :
Repeat Timer
Specifies the length of time
between repeated re-
transmission of network
message waiting notifications.
10–240 s
PC Programming Manual
References
17.1 PBX Configuration—[9-1]
Private Network—TIE Table—
Enhanced QSIG Call
Information (Activation Key
Required)
Feature Manual
References
4.3.5.2 Centralised Voice Mail
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission
PC Programming Manual 531