Panasonic KX-TA616 - System Data Default Set

Features 3-57
3 Features
S
System Data Default Set
This system can re-initialize the system-programmed data. If all the programmed data is
cleared, the system will reset using the default settings by program [999].
• The default setting for each programming item is listed in Section 5.1, Default Values.
• Required System Programming
[999] System Data Clear
• Installation Reference
2.24 System Data Clear
☞
!
!
UCD waiting call: Shows <UCD waiting> for an incoming call via the UCD feature.
When the “UCD waiting call” is answered, it becomes a
“Received call” and a new record is started.
(6) Duration : shows the duration of the call or the UCD call waiting time in
Hours/Minutes/Seconds.
(7) Code: shows the account code appended to the call, account code index number
(e.g.: 13), the extension number which uses the Walking COS feature
(e.g.: 101) or DISA security code status (e.g.: 0). Code “0” indicates a DISA
incoming call without a DISA security code. Codes “1 to 4” indicate a DISA
incoming call with DISA security code 01 to 04 respectively. DISA security
codes are never printed out by SMDR.
• This system can store information of up to 64 calls.
• This data is not deleted even when the system is reset.
• If FLASH is manually sent out during a conversation to make another call without
hanging up, etc., a call record will be printed and a new record started. “F/” will be
printed at the beginning of the dial number on the new record.
• When a host PBX code is entered, “=” will be printed between the code and dialed
number.
• The language used for an SMDR printout can be selected in program [806].
• Connection Reference
2.13 Printer and PC Connection
• Required System Programming
[000] Date and Time Setting
[204] Call Duration Count Start Time
[800] SMDR RS-232C Communication Parameters
[801] SMDR Parameter
[802] Incoming/Outgoing Call Selection for Printing
[803] Secret Speed Dialing/One-Touch Dialing Printing
[804] System Data Dump
[805] SMDR Account Code Selection
[806] SMDR Language Assignment
• Related Feature Reference
Language Selection
!
!
☞