Panasonic KX-TA616 - Hookswitch Flash Timing Range Selection

4-30 System Programming
[207]-[208] 4.2 System Programming
Assigns the maximum time allowed between digits for an outgoing outside call.
Default 10 seconds
• The interdigit timer applies until the toll restriction check is completed. When the timer
expires, an outgoing outside call will be disconnected while dialing, if “Enable” was
selected in program [211] “No Dial Disconnection”.
• For a single line telephone, an outgoing outside call will be released from a DTMF
receiver when the interdigit timer expires.
• Feature Reference
Section 3, Features
Toll Restriction
8
0
2
[208] Interdigit Time
NEXT
SELECT
STORE
END
(5/10/15/20 sec)
☞
Sets the hookswitch flash time range sent from an extension to the system.
MODE 1: 50 to 180 milliseconds.
MODE 2: 80 to 180 milliseconds.
MODE 3: 80 to 650 milliseconds.
MODE 4: 80 to 1000 milliseconds.
MODE 5: 200 to 1000 milliseconds.
Default MODE 4
• Feature Reference
Section 3, Features
Hookswitch Flash
7
0
2
[207] Hookswitch Flash Timing Range Selection
NEXT
SELECT
STORE
END
(MODE1/MODE2/
MODE3/MODE4/
MODE5)
☞
!
!