Panasonic KX-TA616 - DISA Security Codes

System Programming 4-63
4.2 System Programming [512]-[513]
Assigns a maximum of 4 required DISA security codes if “Trunk Security” or “All Security”
is selected in program [511] “DISA Security Type”.
Default All DISA security codes – Not stored
• The used code numbers (not security codes) are printed on the SMDR.
• Feature Reference
Section 3, Features
Direct Inward System Access (DISA)
[512] DISA Security Codes
1
5
NEXT
2
END
security code
4 digits
(0
··· 9)
Assigns the number of times a cyclic tone is detected while the DISA outgoing message is
sent so that the system can recognize the end of the DISA call.
* Disable (Does not detect)
Default 4 Times
• Feature References
Section 3, Features
Direct Inward System Access (DISA), Uniform Call Distribution (UCD)
[513] Cyclic Tone Detection*
1
1
5
NEXT
3
STORE
END
SELECT
(Disable*/
2/3/4 Times)
☞
!
!
☞
*
1
: Required only when the optional OGM/FAX Detection
Card is installed.
code no.
(1 ··· 4)
NEXT
PREV
or
To continue
To continue
STORE
SELECT