EasyManua.ls Logo

Panasonic KX-TA616 - Extension Group; Extension Password; System Password

Panasonic KX-TA616
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Features 3-29
3 Features
E
Extension Group
The system supports 8 extension groups. In an extension group, the following features can
be activated.
• Group Call Pickup: Any member of an extension group can pick up a call directed to
another member in the same group.
• Paging – Group: Any member of an extension group can make a voice
announcement to another group member.
A hunting group, DISA ring group or UCD group is a specific extension group. The
following operation as well as the features above can be activated for a hunting group, DISA
ring group or UCD group.
Hunting Group
An extension group enabled in program [100] “Hunting Group Set” will perform the
Station Hunting feature. See “Station Hunting” in this section.
DISA Ring Group
All extensions in a DISA ring group assigned as an auto attendant destination in
program [501] “DISA Built-in Auto Attendant” will ring simultaneously. Selecting
“DISA1” or “DISA2” in programs [414]–[416] “Outside (CO) Line Mode —
Day/Night/Lunch” is required. Also, you must select “With AA” in program [500]
“DISA Incoming Dialing Mode Selection”.
UCD Group
One extension group assigned as the UCD group in program [520] “UCD Group” can
be the destination of incoming outside calls via the UCD feature. Selecting “UCD” in
programs [414]–[416] “Outside (CO) Line Mode — Day/Night/Lunch” is required.
Required System Program Address
[600] Extension Group Assignment
Related Feature References
Call Pickup, Direct Inward System Access (DISA), Paging, Station Hunting,
Uniform Call Distribution (UCD)
Extension Password / System Password
The extension password assigned by the manager (extension jack 01) to each extension can
be used for the Walking COS feature. The system password is used for entering System
Programming and also before assigning the extension password.
Required System Programming
[002] System Password
Related Feature References
Walking COS
Operating Instructions Reference
1.8 Operator / Manager Service Features, “Extension Password Set (Manager only)”

Table of Contents

Related product manuals