Panasonic KX-TA616 - UCD Busy Mode

4-68 System Programming
[523]-[524] 4.2 System Programming
Selects the operation when the length of time programmed in [521] “UCD Busy Waiting
Time” expires. Intercept or Disconnect is available.
Intercept: The call will be redirected depending on programs [408]-[410] “Flexible
Ringing Assignment–Day/Night/Lunch” (Intercept Routing feature). The
extension which receives a redirected call rings during the length of time
programmed in [526] “UCD Ringing Time after Intercept”.
Disconnect: The call will be disconnected immediately.
Default Intercept
• The above-mentioned intercept is only occurs when “MODE 3” or “MODE 5” is selected
in program [502] “OGM Mode Selection”. If “MODE 4” is selected, the call will be
disconnected after the UCD-END outgoing message. If “MODE 6” is selected and
“Intercept” is assigned in this program, the call will be led to the DISA feature by OGM2.
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[523] UCD Busy Mode*
1
2
5
NEXT
3
STORE
END
SELECT
(Intercept/
Disconnect)
!
!
☞
Selects the operation when all extensions in the UCD group do not answer an outside call
via the UCD feature within the length of time programmed in [525] “UCD Ringing Time
before Intercept”. Intercept or Disconnect is available.
Intercept: The call is redirected depending on programs [408]-[410] “Flexible Ringing
Assignment–Day/Night/Lunch” (Intercept Routing – No Answer feature).
Disconnect: The call is disconnected.
Default Intercept
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[524] UCD Intercept Mode*
1
2
5
NEXT
4
STORE
END
SELECT
(Intercept/
Disconnect)
☞
*
1
: Required only when the optional OGM/FAX Detection
Card is installed.