2.22 Starting the System for the First Time
Installation 2-31
1. Set the Power Switch to the “OFF” position.
2. Plug the AC power cord into the system and an AC outlet.
3. Turn the Power Switch on.
(The power indicator will light.)
4. Perform the following operation with a proprietary telephone connected to JACK 01.
a) Press the PROGRAM button, or set the MEMORY switch to “PROGRAM” on the
back of the telephone.
b) Press #.
c) Enter 1234.
d) Enter 999.
e) Press the NEXT (SP-PHONE) button.
f) Press the SELECT (AUTO ANS/MUTE or AUTO ANSWER/MUTE) button until
“All Para” is displayed.
g) Press the STORE (AUTO/STORE or AUTO DIAL/STORE) button.
h) Press the END (HOLD) button.
i) Press the PROGRAM button, or set the MEMORY switch to “SET” on the back of the
telephone.
The system will be initialized with the default values. If the system does not work properly,
please see 2.24, “System Data Clear”.
CAUTION • The system will continue to be powered even if the Power Switch is turned
“OFF”.
• The power supply cord is used as the main disconnect device. Ensure that the
outlet is located/installed near the equipment and is easily accessible.
To Next Page
Loading...
