Panasonic KX-TA616 - Pulse Speed Selection

If the system is installed behind a host PBX, each outside (CO) line may require an access
code to make an outside call. Up to 8 access codes can be stored for each outside line.
When the programmed codes are dialed, the pause time assigned in program [417] “Pause
Time” is automatically inserted, and toll restriction is applied after the code.
*
1
Outside (CO) line number: 1 through 6 / (All outside lines)
*
2
Insert a “,” for each code using the button on the overlay.
Example:
• Access codes 81, 82 on outside (CO) line number 1
Default All outside (CO) lines – Not stored
• To correct a wrong entry, press the CLEAR button and enter the new one.
• Feature Reference
Section 3, Features
Host PBX Access
4-44 System Programming
[402]-[403] 4.2 System Programming
,
Selects a pulse rate for each outside (CO) line which sets “Pulse Mode” or “Call block
Mode” in program [401] “Dial Mode”. There are 2 pulse rates, Low Speed (10 pps) and
High Speed (20 pps).
* Outside (CO) line number: 1 through 6 / (All outside lines)
Default All outside (CO) lines – Low Speed
0
4
[402] Pulse Speed Selection
3
0
4
[403] Host PBX Access Codes
NEXT
END
access code*
2
Up to 8 access codes
1 or 2 digits
(0···9)
3
0
4
NEXT
STORE
END
1
8
8
1
,
2
(Low/High
Speed)
outside line no.*
1
(1 ··· 6/ )
(1 ··· 6/ )
2
NEXT
SELECT
END
outside line no.*
NEXT
PREV
or
SELECT
To continue
To continue
STORE
NEXT
PREV
or
!
!
☞
SELECT
STORE
To continue
To continue