• If the selected extension numbering plan is the same as the previously stored one, 2
beeps will be heard.
• If “Plan 2” or “Plan 3” is selected, the default extension numbers will change
automatically as follows.
Plan 2: extension jacks 01 through 24 – extension numbers 101 through 124
Plan 3: extension jacks 01 through 24 – extension numbers 11 through 34
• If “Plan 2” or “Plan 3” is selected, some feature numbers will also change. Refer to
the attached leaflet for details.
• A double entry of the extension number is invalid. If the programmed extension
number is the same as a previously stored one, 2 beeps will be heard when the STORE
button is pressed. When extension number 103 has already been assigned to jack
number 03, to assign extension number 103 to the jack number 05, change the
extension number of jack number 03 to another one. Then assign extension number
103 to jack number 05.
• If a Voice Processing System (VPS) is connected to the system, select “Plan 1” or
“Plan 2” in this program and “Enable” in [103] “DTMF Integration”, so that the
DTMF integration between VPS and the system can be enabled.
• If a rotary telephone is used at any extension, select “Plan 1” in this program.
• Feature Reference
Section 3, Features
Intercom Calling
System Programming 4-11
4.2 System Programming [009]-[010]
[010] LCD Time Display Selection
Selects how the current time and date will be displayed on a proprietary telephone while
idle. Either 12 hour or 24 hour (military time) can be selected.
Display example:
When “12 HOUR” is selected: Jan 1 11:20PM
When “24 HOUR” is selected: 1 Jan 23:20
Default 12 HOUR
• Programs [000] “Date and Time Setting” and [007] “Time (Day/Night/ Lunch) Service
Start Time”, and the Timed Reminder feature are assigned using 12-hour time
regardless of this program. The SMDR printout is also printed using 12-hour time.
To Next Page
Loading...
