Panasonic KX-TA616 - SMDR Parameter

4-84 System Programming
[801]-[802] 4.2 System Programming
Assigns the following 2 printing parameters to match the SMDR output with the paper size
used in the printer.
Page Length: Sets the number of lines per page.
Skip Perf: Sets the number of lines to be skipped at the end of every page.
Default Page length – 66 lines
Skip perforation – 0 line
• The page length should be at least 4 lines
longer than the skip perforation length.
• To correct a wrong entry, press the CLEAR
button and enter the new one.
• Feature Reference
Section 3, Features
Station Message Detail Recording (SMDR)
108
[801] SMDR Parameter
NEXT
STORE
NEXT
< Sets the page length >
< Sets the skip perforation >
!
!
66 lines
page
length
skip
perforation
machine
perforation
Standard paper
for the SMDR
(11 inches)
page length
(4 ··· 99)
skip perforation
(0 ··· 95)
END
STORE
Determines which calls will produce an SMDR printout.
*
1
Outgoing: On (Print all calls) / Off (No printing) / Toll (Print toll calls only)
*
2
Incoming: On (Print all calls) / Off (No printing)
Default Outgoing calls / Incoming calls – On
• If “Outgoing; Toll” is selected, only calls which are checked in programs [302]–[305] “Toll
Restriction – Classes 2 through 5 Denied Codes” and are allowed, are printed out.
• Feature Reference
Section 3, Features
Station Message Detail Recording (SMDR)
[802] Incoming/Outgoing Call Selection for Printing
2
0
8
NEXT
SELECT
(On/Off/Toll)*
1
STORE
NEXT
SELECT
(On/Off)*
2
STORE
< Sets an outgoing call > < Sets an incoming call >
!
!
END
<Example>
☞
☞
(Perforation)