Enables or disables connecting a single line telephone (SLT) to receive pulse signals for each
extension.
* Extension jack number: 01 through 24 / (All extension jacks)
Default All extension jacks – Enable
• If you select “MODE 1” in program [207] “Hookswitch Flash Timing Range Selection”
and “Enable” in this program, the system will distinguish between a pulse signal and
hooking depending on the situation. When you select “Disable” in this program, if “1” is
dialed during the pulse mode, the system will regard it as hooking and all other numbers
will be disregarded.
• Feature Reference
Section 3, Features
Hookswitch Flash
System Programming 4-77
4.2 System Programming [614]
To Next Page
Loading...
