4-18 System Programming
[106]-[108] 4.2 System Programming
Enables or disables a station locked extension to send a flash signal during a conversation
with an external party.
Default Disable
Enables or disables the 6 DTMF receivers to check whether the DTMF receivers are
activated normally or not. Refer to the Section 6 Troubleshooting, “While Operating” for
further information on checking the DTMF receivers.
* DTMF receiver number: 1 and 2 (for checking extension jacks 01 through 08)/
3 and 4 (for checking extension jacks 09 through 16)/
5 and 6 (for checking extension jacks 17 through 24)
Default All DTMF receivers – Enable
[106] External Paging Access Tone
Enables or disables the confirmation tone before paging is sent over the external pager.
Default Enable
• Feature Reference
Section 3, Features
Paging