4-4 System Programming
4.1 Before System Programming
Assigns a maximum 6 outside (CO) line groups. Each outside (CO) line must be assigned to
an outside (CO) line group. For example, if there are multiple telephone service companies
available, outside (CO) lines can be grouped by the company.
*
1
Outside (CO) line number: 1 through 6 / (All outside lines)
*
2
Outside line (TRK) group number: 1 through 6
Default Outside (CO) line 1 through 6 – Outside (CO) line group 1 through 6
• Each outside (CO) line can only belong to one outside (CO) line group.
• Feature Reference
Section 3, Features
Outside Calling
Provides the factory default setting. If you change the setting,
write the programmed data in the programming table listed in
section 7, Programming Tables.
[404] Outside (CO) Line Group Assignment
Program address Program title
Additional information
Program sequence:
1. Enter program address “404”.
2. Press “NEXT”.
3. Enter the outside (CO) line
number (1 through 6) or press
to select all outside (CO) lines.
4. Enter the outside (CO) line
group number (1 through 6).
5. Press
“
STORE”.
6. Press “END”.
To continue assigning another
outside (CO) line number, press
“SELECT” instead of “END”
and repeat from step 3.
You can also continue assigning
by pressing “PREV” or
“NEXT” instead of “END”.
You can go to the previous or
next outside (CO) line and
repeat from step 4.
!
!
Additional Information
• When you press , for example in step 3 in program [404], if all outside (CO) lines have
been assigned as outside (CO) line group 1, “CO : TRK GRP – 1” will be displayed. If
each outside (CO) line has been assigned to a different outside (CO) line group,
“CO : Mixed” will be displayed.
• You can press the SELECT button repeatedly to select the desired parameter, if available.
• You can use the or button to move to the next/previous step, if available.
(1
···
6/ )
To Next Page
Loading...
