To Next PageTo Next Page
Why do I hear two short beeps during a conversation on my Panasonic Handsets?
If you hear two short beeps during a conversation on your Panasonic handset, the radio signal is weak. Try moving closer to the base unit.
What to do if my Panasonic Handset does not work?
If your Panasonic handset isn't working, it might be due to a drained battery. Charge the battery fully. Alternatively, the power might be off. In that case, turn it on or try re-inserting the battery and then setting the handset on the charger.
Why is the charge indicator flashing red on my Panasonic Handsets?
If the charge indicator flashes red rapidly on your Panasonic handset, the charger is not connected properly. Make sure the battery is inserted properly and set the handset in the charger correctly.
How to fix Panasonic Handsets headset that doesn't work?
If the headset on your Panasonic handset isn't working, make sure the headset tone setting is set to "On". Also, ensure the headset jack is connected properly.
Why does my Panasonic Handsets say "No Service"?
If your Panasonic handset displays "No Service" and you hear beep tones, it could be that the handset is out of range. Try moving closer to the base unit or try again later.
Why I can't dial on my Panasonic Handsets?
If you cannot dial on your Panasonic handset, key lock mode might be on. To cancel the mode, press and hold the key lock button for about 2 seconds.
Why is my headset not working with my Panasonic IP Phone?
If your headset isn't working with your Panasonic IP Phone, make sure the headset tone setting is set to "On". Also, verify that the headset jack is properly connected.
Why does my Panasonic Handsets beep after charging?
If your Panasonic handset beeps and indicates it needs to be charged even after charging for 6 hours, the battery charge contacts may be dirty. Clean the battery charge contacts without damaging them and charge once more. It may also be time to replace the batteries with new ones.
What to do if Panasonic Handsets stops working during operation?
If your Panasonic handset stops working during operation, an unknown error may have occurred. Try turning the handset off and then back on. Alternatively, re-insert the battery and try again.
Why is there so much noise on my Panasonic Handsets?
Frequent noise during calls on your Panasonic handsets might be due to interference from nearby electrical appliances or being too far from the base unit. Try placing the handset and base unit away from other electrical appliances and move closer to the base unit.
General| Speakerphone | - |
|---|---|
| Voice codecs | G.711a, G.722, G.722.2, G.729A |
| Handset type | Wireless handset |
| Product type | IP Phone |
| Product color | Black |
| DECT connectable | Yes |
| Number of handles included | 1 pc(s) |
| Number of DECT wireless handsets | 8 |
| Display diagonal | 1.8 \ |
| Frequency band | 1.88 - 1.90 GHz |
| Lines quantity | - lines |
| Phonebook capacity | 500 entries |
| Networking standards | IEEE 802.1Q, IEEE 802.3af |
| Ethernet LAN (RJ-45) ports | 1 |
| Standby time | 200 h |
| Battery type | AAA |
| Battery capacity | 630 mAh |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
| Harmonized System (HS) code | 85171800 |
Weight and Dimensions| Depth | 25.5 mm |
|---|---|
| Width | 47.8 mm |
| Height | 153.2 mm |
| Weight | 117 g |
