247
Setting Inspection Conditions
For “Automatic Switch” or “User-Defined” execution mode
1.
Select "Condition" in judgement output setting window.
“Condition” setting window is displayed.
2.
Select “Total Judge.” in the item selecting field
on the upper left.
The list of the Total Judgement by blocks is
displayed.
3.
Select “Condition” column of the block No. to set
in the list and select a judgement type.
For details, refer to the procedure of “Execute All”
execution mode.
4.
Select “Checker No.” column and set a
judgement number.
5.
After setting is completed, press the CANCEL
key.
To Next Page
Loading...
