Panasonic PV500 - Setting Capturing Conditions of Camera

58
Setting Inspection Conditions
Chapter 4
4.3 Setting Capturing Conditions of Camera
Set conditions of capturing an image of an object.
Camera Type:
Four cameras (or two cameras) of two types can be connected. Set a type of camera for each connecting
camera ports. (ANPVC1021: Discontinued as of August 2011.）
Camera Trigger:
When connecting multiple cameras, you can select Common Trigger or Individual Trigger. Common Trigger
captures images simultaneously by all cameras and Individual Trigger captures them at separate timings.
Selecting Common Trigger allows using Detect Trigger function which detects whether an object is in the
inspection area.
Capturing Condition for Each Camera
• Shutter speed: page 64.
• Camera gain: page 64.
• Offset:page:page 67
• Capture delay: page 65.
• FLASH delay, FLASH span: page 69.
• Partial imaging: page 70.
• Calibration: page 71.
Error if Checker Area outside Image:
This function cancels the checker when its area is outside a captured image.
On camera trigger, capturing condition of camera, and the error if checker area is outside the image, you can
set individually for each type other than using common setting.