Panasonic PV500 - Setting Default Variable (System Register)

337
Environment Settings
Chapter 6
INDEX
6.2.4 Setting Default Variable (System Register)
PV500 offers eight value registers. These registers can be used in an expression of numerical calculation, or
can be referred for a drawing position or figure size of character/figure drawing.
The values of the registers can be changed by inputting a command through COM.0 interface or Ethernet
interface from the external device.
Setting Default Value to Store in Registers
The value can be changed and read from the external device.
1
. Select "System Register" in “System Settings” setting window.
2
. Select register No. to change the value.
3.
Specify the value and press the ENTER key.
The available values range from -9,999,999.999 to +9,999,999.999.