Parker 890SD - Powering-up the Unit

890SD Standalone Drive
Page 5-42 890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
Powering-up the Unit
1. Apply the 3-phase supply to the 890SD Standalone Drive.
2. Select LOCAL mode operation:
♦ The Keypad will display the Remote Setpoint parameter (%).
3. You MUST carry out an Autotune if you intend to use the drive in Sensorless Vector Fluxing Mode
or Closed-Loop Vector Mode - go to page 4-
43. If you are using the drive in Volts/Hz Mode (Open-
Loop Drive) an Autotune is not necessary - go to page 4-
48.
REMOTE
LOCAL
Hold the Stop key down until
the display spells
Release the key to display
the previous menu
for example,Local Setpoint