Parker 890SD - Special Menu Features

The Keypad
Page 8-26 890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
Special Menu Features
Resetting to Factory Defaults (2-button reset)
Power-up the drive whilst holding the keys as shown to
return to factory default settings.
This loads default values for all pre-defined parameters.
Then press the
key.
Selecting the Menu Level
For ease of operation the drive can display full or reduced menus.
Navigate to the S35 parameter (SET::S35) and press the
key. This toggles full or
partial menu detail. Change the value of the parameter for a different viewing level:
0 = Operator mode (OPER menu and reduced SET menu (S35) only)
1 = Basic view (all menus)
2 = Advanced view (no effect on 6511 keypad)
Hold down the keys opposite:
Power-up the drive, continue
to hold for at least 1 second
HOLD