Keypad Menus
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page 9-29
8
9
10
11
B
C
D
1
2
3
4
5
6
7
E
The SETUP Menu
This menu contains all the parameters available to you when using the DSE 890 Configuration Tool.
ADVANCED view level must be selected to view this menu. It is only available on the 6901 keypad when
using the 890CD Common Bus Drive and 890SD Standalone Drive.
Note We recommend that you program the 890 using the DSE Configuration Tool.
For details of the parameters in this menu, refer to Appendix D.
The SYSTEM Menu
SAVE CONFIG
The SAVE CONFIG menu saves your current settings.
To save an application press the M key when displaying the SAVE CONFIG menu. Press the ▲ key to
confirm, as instructed.
Saving again will overwrite the previous information.
Saved information is stored during power-down and is restored at power-up.
This does not save the link configuration. It saves information for MMI parameters.
To Next Page
Loading...
