Parker 890SD - TRIPS STATUS

Programming
Page D-142 890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
TRIPS STATUS
SETUP::TRIPS::TRIPS STATUS
The Drive supports advanced and flexible trip logic to support monitoring of the Drive itself, the motor and the load. This
function block provides a view into the current trip condition(s) and allows some trips to be disabled.
Parameter Descriptions
DISABLE TRIPS
PREF: 97.01 Default: 0300 Range: 0x0000 to 0xFFFF
Use this parameter to disable trips. Not all trips may be disabled, the DISABLE TRIPS mask is ignored for trips that cannot be
disabled. See below for which trips may be disabled and how this parameter is formed.
DISABLE TRIPS+
PREF: 97.02 Default: 0840 Range: 0x0000 to 0xFFFF
Use this parameter to disable trips. Not all trips may be disabled, the DISABLE TRIPS mask is ignored for trips that cannot be
disabled. See below for which trips may be disabled and how this parameter is formed.
ACTIVE TRIPS
PREF: 97.05 Default: 0000 Range: 0x0000 to 0xFFFF
Indicates which trips are currently active. These parameters are a coded representation of the trip status. See below for a
description of how this parameter is formed.
ACTIVE TRIPS+
PREF: 97.06 Default: 0000 Range: 0x0000 to 0xFFFF
Indicates which trips are currently active. These parameters are a coded representation of the trip status. See below for a
description of how this parameter is formed.
WARNINGS
PREF: 97.07 Default: 0000 Range: 0x0000 to 0xFFFF
Indicates which conditions are likely to cause a trip. These parameters are a coded representation of the warning status. See
below for a description of how this parameter is formed.
WARNINGS+
PREF: 97.08 Default: 0000 Range: 0x0000 to 0xFFFF
Indicates which conditions are likely to cause a trip. These parameters are a coded representation of the warning status. See
below for a description of how this parameter is formed.