Parker 890SD - Page 499

Programming
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page D-155
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
Notes
You can record your application’s settings here.
Output parameters are not saved in non-volatile memory unless indicated.
1. This input parameter is not saved in non-volatile memory.
2. This input parameter can only be written to when the drive is stopped.
3. The default value is dependent on the power board.
4. The default value is dependent on the frequency board.
5. This parameter is not set from DSE on a partial install.