120
3
Taking Pictures
Set the image tone of still pictures.
You can select from [Bright] (Default setting), [Natural] or [Monochrome].
1
Press the 3 button in A mode.
The [A Rec. Mode] menu appears.
2
Use the four-way controller (23) to select [Image
Tone].
3
Press the four-way controller (5).
A pull-down menu appears.
4
Use the four-way controller (23)
to select a finishing tone.
5
Press the 4 button.
The setting is saved.
6
Press the 3 button.
The camera returns to capture status.
• Looking at the light directly does not pose a safety hazard. However,
do not look directly into the emitter from a very short distance.
• The camera does not emit the focus assist light under the following
conditions:
- when the capture mode is set to C (Movie)
- when s (Infinity) or \ is selected as the focus mode
Setting the Image Tone
When [Monochrome] is selected, [Tone Adjustment] appears on the
[A Rec. Mode] menu for setting the tone of monochrome images
instead of [Saturation].
1/4
Bright
Natural
Monochrome
AUTO
AWB
Rec. Mode
MENU
Cancel
Recorded Pixels
Quality Level
Sensitivity
ISO Corction in AUTO
White Balance
ISO80-400
Image Tone
OK
OK
To Next Page
Loading...
