Pentax X90 - Connecting Camera to Computer; USB Connection Mode Settings; Connecting Camera and Computer

225
8
Viewing Images on a Computer
Set the device to which the camera is connected with the USB cable.
1 Turn your camera on.
2 Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
3 Use the four-way controller (23) to select [USB
Connection].
4 Press the four-way controller (5).
A pull-down menu appears.
5 Use the four-way controller (23)
to select [MSC].
6 Press the 4 button.
The setting is saved.
Setting the USB Connection Mode
Make sure to set the USB Connection mode before connecting your
camera to the computer. You cannot perform the following setting if the
camera is connected to your computer with the USB cable.
2/4
MENU OK
OK
MSC
PTP
Setting
Video Out
USB Connection
HDMI Out
Eye-Fi
Auto
Brightness Level
Power Saving
5 sec.
Cancel