235
8
Viewing Images on a Computer
Start transferring images from the Eye-Fi card.
In A mode or Q mode (single-image display), images will be
automatically transferred when no operation is performed for 5 seconds
or more.
1
Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2
Use the four-way controller (23) to select [Eye-Fi].
3
Use the four-way controller (45)
to change the setting to O.
Setting Up an Eye-Fi Card
• If the following setting is made, images that have not been transferred
will be transferred automatically. Images will also be transferred when
images are taken, new images are saved, or images are overwritten.
Be sure to confirm the images before making following setting.
• [Eye-Fi] is set to P (Off) by default. Even if it is set to O (On), it will be
reset to P when the camera is turned off.
• Images will not be transferred in the following situations:
- when an available wireless LAN access point cannot be found
- when the battery level is low (the battery level indicator is
y (yellow) or z (red))
• When transferring large data files such as a large movie file, the
internal temperature of the camera may become high and may cause
the camera to turn off automatically for the sake of circuit protection.
• Auto Power Off does not function when images are being transferred.
• Transferring a large number of images may take some time. It is
recommended to use the optional AC adapter kit (K-AC106).
2/4
NTSC
MSC
Eye-Fi
MENU
Setting
Video Out
USB Connection
HDMI Out
Auto
Brightness Level
Power Saving
5
sec.
Exit
To Next Page
Loading...
