Pentax X90 - ISO Correction in AUTO Mode

125
3
Taking Pictures
4 Use the four-way controller (23)
to change the setting.
You can check the result of selected white
balance setting on the preview image each
time you press the four-way controller
(23).
To select a type of fluorescent lighting,
select an icon for the fluorescent light and press the four-way controller
(5) and then use the four-way controller (23) to select a type of
lighting.
5 Press the 4 button.
The setting is saved.
6 Press the 3 button.
The camera returns to capture status.
Refer to the section “Manual Setting” for instructions on adjusting the
white balance manually.
Have a blank sheet of white paper or similar material ready.
1 In the [White Balance] screen, use the four-way
controller (23) to select K.
2 Point the camera at the blank
sheet of paper or other material so
that it fills the frame displayed in
the center of the screen.
3 Press the shutter release button fully.
The white balance is automatically adjusted.
Saving the White Balance setting 1p.144
Manual Setting
White Balance
MENU
Cancel
Cancel
Auto
Auto
OK
OK
OK
D
White Balance
MENU
Cancel
Adjust
D
SHUTTER
OK
OK