AS-i EtherNet/IP Gateway
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
29
In the advanced mode, however, the settings are protected, as long as the supe-
rior fieldbus is running.
The device starts in the classical mode (see chapter 7). Press ESC to switch to the
extended mode.
In the extended mode, the selection can be moved up and down with the arrow
buttons.
Pressing OK will switch to the selected function or menu. Pressing ESC will switch
back to the previous menu.
To edit data values highlight them with the selection bar, press OK, then change
them with the arrow-buttons and confirm with OK. The ESC-button cancels the
editing process.
All possible addresses are displayed one after the other from 1A to 31A and from
1B to 31B. Data for single slaves are displayed at the addresses 1A - 31A.
In the classical mode, it is possible to change settings while the device is in
operation. This can lead to failure of the plant (e. g. changing the address of
an AS-i slave).
1.12 A
ETHERNET/IP
QUICK SETUP
SLAVE ADDR TOOL
SLAVE TEST TOOL
SETUP
IO+PARAM.TEST
DIAGNOSIS
ADV.DIAGNOSIS
AS-I SAFETY
LANGUAGE
DISPLAY CONTRAST
To Next Page
Loading...
