AS-Interface
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
32
7.1.2.5 TCP/IP configuration
Over this menu the values for the TCP/IP Configuration (IP address, net mask and
gateway) can be entered.
7.2 Ethernet Object
This menu corresponds to the EtherNet/IP Ethernet Link Object (Object code F6)
and informs about the following ethernet attributes:
IF Speed Attribute 1: Interface Speed
(the menu indicates the momentary data transfer rate)
IF Status Attribute 2: Interface Flags
(the menu indicates the connecting status of the ethernet
interface)
Physical ADDR. Attribute 3: physical address
(the menu indicates the ethernet address)
IF Counters Attribute 4: Interface Counters
(the menu indicates the ethernet-packet counter)
Media Counters Attribute 5: Media-Specific counters
(the menu indicates the state of the ethernet-specific counter).
Start the gateway again, so that the changes become effective!
Not all RFC1213 counter are implemented.
Not all RFC1642 counter are implemented.
ARM FIRMWARE
TCP/IP OBJECT
ETHERNET OBJECT
IF SPEED
IF STATUS
PHYSICAL ADDR.
IF COUNTERS
MEDIA COUNTERS
To Next Page
Loading...
