Pepperl+Fuchs VBG-EN-K20-D - LCS (List of Slaves Having Caused a Configuration Error); Fault Detector

AS-i EtherNet/IP Gateway
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
51
7.9.2 LCS (list of slaves having caused a configuration error)
This list shows for each single AS
-i slave whether at least one configuration error
was caused by an enormous telegram transmission. This function is especially im-
portant if the configuration error only occurs short-time.
Empty field: No error
X: AS
-i slave caused a configuration error.
7.9.3 Fault detector
The menu "Fault Detector" shows information about the AS-i detector and allows
deleting of the AS-i detector´s history. Furthermore a list of abbreviations in plain
language can be found is in the section "Help".
By selecting "Reset" the history of the AS-i detector can be deleted.
In the section "Historic" the appeared error messages of the AS-i detector are lis-
ted since the last "Reset".
In the section "Actual" the actual appeared error messages of the AS-i detector are
listed.
Following error messages are possible:
• Duplicate address (the 2 lowest slave addresses are displayed, at which a du-
plicate address exist).
• Earth faults
•Noise
• Overvoltage
RESET
APF- I 1A-x
2A- I 3A-
4A-x I 5A
FAULT DETECTOR
RESET
HISTORIC:
EFLT OVRV NOIS
ACTUAL:
EFLT OVRV NOIS
DUP ASI ADR:
0 I 31B
HELP:
EFLT EARTH FAULT
OVRV OVERVOLATAGE
NOIS NOISE
DUP ASI ADR
DUPLICATE ASI
SLAVE ADDRESS