AS-Interface
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
38
7.6 Setup (configuration of AS-i circuit)
7.6.1 AS-i circuit
To reach this setup menu you have to change the desired AS-i circuit by using the
arrow and the OK buttons.
The function is only implemented in the double master.
It makes possible to change the AS
-i circuit that is currently active for being ope-
rated.
The active circuit is marked by the cursor.
7.6.2 Description of setup mode
Within the menu "Setup", one of the following submenus can be chosen:
• AS-i Slave Addr (AS-i Slave Address)
• Force Offline (switch AS-i Master offline)
• Operation Mode
• Store Act Cfg (store actual detected configuration)
• Permanent Param (projected parameter)
• Permanent Cfg (projected configuration data)
• Addr. Assistant (address assistent)
• LOS (list of offline-slaves)
• Auto Adr Enable
• Supply (option by single master)
• Factory Reset (rest for the factory adjustment)
AS-I CIRCUIT 1
AS-I CIRCUIT 2
AS-I SLAVE ADDR
FORCE OFFLINE
OPERATION MODE
STORE ACT CFG
PERMANENT PARAM
PERMANENT CFG
ADDR. ASSISTANT
LOS
AUTO ADDR ENABLE
SUPPLY
FACTORY RESET
To Next Page
Loading...
