Pepperl+Fuchs VBG-EN-K20-D - Get Transm.err.counters (GET_TECA)

AS-i EtherNet/IP Gateway
Command Interface
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
77
8.3.4.11 Get transm.err.counters (GET_TECA)
With this call the error counters of all single slaves/A-slaves can be read (see
chapter 9).
With every reading out of the counts, the error counters will be restarted.
The counts are being read out via the corresponding host interface and will be de-
leted with every read access. The counter´s value is limited to 254. 255 will cause
a counter overflow.
The counts could be independent of the counters, which are displayed in the dis-
play of the gateway.
Request (if O ≡ 1)
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
162
16
2T 1 circuit
30A1A2A3A4A5A6A7A
……
10 24B 25B 26B 27B 28B 29B 30B 31B
Response
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
162
16
2T result
In order to get the real number of transcription errors, multiply the value with 2
Request
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
163
16
2T – circuit
Response
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
163
16
2T result
3APF
4slave 1A
……
34 slave 31A