AS-Interface
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
34
7.3.1 Control menu (option)
7.3.1.1 AS-i control
7.3.1.2 AS-i control information
This function displays the current status of the AS-control (control program).
START BIT SET: the control program was started.
START BIT RESET: the control program was stopped.
RUNNING: the control program is running.
STOPPED: the control program was stopped.
The control program can be stopped even though the start bit was set. Example:
any configuration error occurs, or the master is in the configuration mode.
CYCLE TIME ACT: current cycle time of the control program.
CYCLE TIME MAX: maximal cycle time of the control program since its last start.
7.3.1.3 AS-i control run
CONTROL RUN: the control program can be stopped with this function. It modifies
the start bit in the menu Control Info.
RUN: the control program has been started. Even if the start bit is set, the control
program can be stopped; example: any cofiguration error occurs, or the master is
in the configuration mode.
CHANGE: the configuration program is stopped.
CONTROL INFO
CONTROL RUN
CONTROL FLAGS
CONTROL INFO
START BIT SET
RUNNING
CYCLE TIME
ACT: 2MS
MAX: 5MS
CONTROL RUN
RUN
CHANGE
To Next Page
Loading...
