Pepperl+Fuchs VBG-EN-K20-D - Set List of Offline Slaves (SET_LOS and SET_LOS_R6 (6 Dh))

AS-Interface
Command Interface
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
76
8.3.4.10 Set list of offline Slaves (SET_LOS and SET_LOS_R6 (6Dh))
The call SET_LOS_R6 (6D
16
) differs to the call GET_LOS in the half long LOS list.
With the bit 2
5
is selected if the upper (=1) or lower (=0) part of the LOS is written.
With this call, the list of slaves causing the offline phase when a configuration error
occurs in being defined (List of Offline Slaves, LOS).
The user can choose the reaction of the master when a configuration error occurs.
The master can be switched offline when an important slave causes a configura-
tion error; less important slaves can send an error to the host, AS-i however will
not be switched offline.
Request
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
161
16
2T O circuit
Response (if O ≡ 0)
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
161
16
2T result
37A6A5A4A3A2A1A0A
……
10 31B 30B 29B 28B 27B 26B 25B 24B
Response (if O ≡ 1)
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
161
16
2T result
30A1A2A3A4A5A6A7A
……
10 24B 25B 26B 27B 28B 29B 30B 31B
Request (if O ≡ 0)
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
162
16
2T O circuit
37A6A5A4A3A2A1A0A
……
10 31B 30B 29B 28B 27B 26B 25B 24B