AS-i EtherNet/IP Gateway
Operating in Advanced Display Mode
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
39
7.6.3 AS-i Slave Adr (set/change slave address)
With this function the address of a slave can be changed.
To change the address select the menu entry "OLD ADDRESS" and afterwards
select the address of the slave which address should be changed. The new
address of the slave has to be set in the menu entry "NEW ADDRESS". The
addressing is carried out by pressing the OK button.
7.6.4 Force offline
This function shows the current state of the AS
-i Master:
Yes:AS
-i Master is offline.
No:AS
-i Master is online.
With "Change", this state can be modified.
Switching the AS-i master offline puts the AS-i circuit into the safe state. The AS-i
master has to be offline if an AS-i slave should be addressed via the IR-interface.
7.6.5 Operation mode
This function shows the current operation mode of the AS
-i master:
Protected Mode:Protected mode
Config Mode:Configuration mode
With "Change" the operation mode can be changed.
Only in configuration mode parameters and configuration data can be stored.
AS-I SLAVE ADDR
OLD ADDRESS 21A
NEW ADDRESS 03B
FORCE OFFLINE
NO
CHANGE
OPERATION MODE
CONFIG MODE
CHANGE
To Next Page
Loading...
