To Next Page

To Previous Page

NOTICE:

When the exposure is compensated in the

Manual mode, the dierence between the

metered value and the compensated value

will be displayed on the viewnder LCD. In

the B (Bulb) mode, the dierence with the

metered value is not displayed.

Increment of the aperture and shutter

speed value can be set at either 1/3 or

1/2-stop.

The assignments of the front and rear dials

can be swapped.

Rotation direction of the dials to change the

values can be altered.

The selected aperture and shutter speed

can be locked.

NOTICE:

When the set value matches with the

metered value, the dierence indicator will

show “0.0”.

Manual Mode (M)

This mode is used to set both the aperture and shutter speed for total

exposure control. Varying shutter speeds can be selected, including “bulb”,

“tIME” and manually from 60 mins to 1/4000 sec. Aperture values can be set

from maximum to minimum aperture.

1. Turn the exposure mode setting dial to “M” (Manual) position.

2. Turn the rear dial to set the desired aperture.

3. Turn the front dial to set the desired shutter speed.

4. When the shutter release button is half pressed, the dierence between

the present settings and the metered value is displayed in the viewnder’s

LCD panel. The value is displayed in 1/3 stop increments within a range of

±6 EV.

When the dierence between the set value and the metered value is greater

than ±6EV and the set value is lower than the metered value, the indicator in

the viewnder LCD shows “– u –.” Contrarily when the set value is higher than

the metered value, the indicator shows “– o –.”

PhaseOne IQ Series User Manual

Questions and Answers: