Using the System
HD11 XE Getting Started
4535 612 62651
4
100
b. Plug the video print trigger cable into the print trigger connector on the
back of the video printer, and plug the other end of the cable into the
print trigger connector on the I/O panel on the back of the cart. For an
illustration, see Figure 4-2.
NOTE
On some video printers, the video print trigger connector may be labeled Remote.
5. Reconnect the system’s power cord to the power source.
6. Turn on the video printer, and then turn on the system.
For information on assigning a record key, see “Assigning Keys to Peripherals” on
page 103.
Connecting a Plain-Paper USB Printer
This section provides instructions for connecting a plain-paper USB printer to
your system.
NOTES
• Check with your Philips-qualified service representative before purchasing or
connecting a plain-paper USB printer to make sure it is compatible with the
ultrasound system and to obtain a Commercial Off-the-Shelf Software
(COTS) CD-ROM. The COTS CD-ROM includes the printer driver informa-
tion necessary for your printer to communicate with the system.
• Because a plain-paper printer is typically larger than the Sony printers, it does
not fit on the system cart. Use a 3-m (10-ft) USB cable to connect the
plain-paper printer to the USB connector on the back of the system.
To Next Page
Loading...