Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 500 automated external defibrillator Modes of Operation
5-22
Computer-Assisted Test Mode Page 2 of 3
You must install the Computer-Assisted Test program from the LIFEPAK 500
AED Electronic Service Manual CD-ROM onto your local hard disk. To install the
Computer-Assisted Test program (lp500pip.exe):
1. Use Windows File Manager or Explorer to locate and open the “piptest”
folder on this electronic service manual CD-ROM.
2. Double-click on the setup.exe icon to launch the installer application.
3. Follow the instructions given on the screen to complete the installation.
Note: Accept all defaults suggested by the installer for placement of files.
4. The installer creates two subdirectories on your local hard disk:
■ C:\lp500pip contains the following four files:
– lp500pip.exe
– pip_gui.uir
– uninst.exe
– uninst.lrm
■ C:\cvirte contains the following three files:
– cvirt4.exe
– Bin (a subdirectory)
– Fonts (a subdirectory)
To Next Page
Loading...
