Pitney Bowes DM300C - Maintaining the Moistener; Removing the Moistener (Dm300 C)

12-12
12 • Maintenance
SV62261 Rev. C
1. Push down on the blue re lease lever on the moistener.
Removing the Moistener (DM300c)
Release Lever
2. Pull the moistener straight out to the left.
3. Open the hinged brush holder.
4. Grasp the bristles and slide the brush out of the hinged brush
hold er, toward the front of the moistener tank.
Brush HolderBrush
s
e
n
o
J
e
u
S
3
2
2
e
t
R
1
2
3
4
5
,
n
w
o
T
r
e
H
Maintaining the Moistener
If you notice incomplete or poor sealing and the moistener tank is full,
you may need to clean the moistener brush or wick. If seal quality
doesn’t improve after cleaning, you can replace the stripper blade and
brush assembly or wick as needed. See Chapter 14, Supplies and Op-
tions for instructions on ordering these supplies for your machine.