12-18
12 • Maintenance
SV62261 Rev. C
i
NOTE: This procedure assumes you have already removed the
stripper blade/brush assembly (see previous pages).
1. Open the feeder access cover (DM400c) or feeder/WOW cover
(DM475), remove the moistener bottle, and place it on the table
top with its cap facing up.
Cleaning the Shield and Wick (DM400c/DM475)
Maintaining the Moistener (cont'd)
2. Pull the moistener tank (located under moistener bottle) straight
out towards you. Gently lift the tank up and out.
IMPORTANT:
The moistener tank may be full of E-Z Seal
®
sealing solution.
If so, you can pour the solution back into the moistener bottle
or into a receptacle.
DM400c Moistener Bottle
DM475 Moistener Bottle
DM400c Moistener Tank
DM475 Moistener Tank
To Next Page
Loading...
