3
3.43
8. Remove the high tension leads
w
from the engine
and remove the nuts
e
from each exhaust flange at
the engine.
9. Remove the exhaust springs retaining the exhaust
pipe to the silencer and remove the pipe from the
vehicle. Insert a clean shop towel into the engine
exhaust ports.
10. Remove the rubber strap retaining the ECU to the
airbox.
11. Remove the (2) screws retaining the lower portion of
the airbox to the frame.
12. Remove the breather hose from the side of the
airbox.
13. Disconnect wire harness
r
from ignition coil, intake
air temp sensor, and IAC valve.
14. Remove the two hoses
y
from the IAC valve.
15. Remove the screws
u
that retain the intake runners
to the throttle body.
16. Lift up on the air box and rotate it towards the left
side of the vehicle. Open the wire harness retainer
and remove the harness. Set the airbox assembly
aside.
IMPORTANT
DO NOT attempt to remove the intake runners from the
intake plenum or remove the plenum from the airbox.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
