2
2.21
1. Remove the spark arrestor nut
q
and bolt
w
.
2. Remove the spark arrestor
e
.
3. Place the transmission in park, and start the engine.
4. Purge carbon by momentarily revving the engine
several times.
5. Cover the exhaust outlet and lightly tap the silencer
with a rubber mallet, and then rev the engine
momentarily a few more times.
6. Stop the engine and allow the silencer to cool.
7. Use compressed air and a non-synthetic brush to
clean the arrestor screen.
8. Reinstall the arrestor and fastener, and torque the
retaining screw to specification.
TORQUE
Spark Arrestor Fastener
8 ft/lbs (11 Nm)
ENGINE MOUNT FASTENER TORQUE
Check engine mount fasteners
q
and ensure they are
tight. Also inspect the condition of the rubber mounts. If
mounts are cracked or show signs of fatigue, replace
them.
MAINTENANCE
To Next Page
Loading...
