10
10.3
2018 850 / 1000 SPORTSMAN
HEADLIGHT POD
HEADLIGHT POD DISASSEMBLY
1. Remove the screws retaining the front of the pod.
2. Remove the front half of the pod.
3. Remove the Screws retaining the rear of the pod.
4. Disconnect the wiring harness form the electrical
components fastened to the pod.
NOTE
Take note of all vent lines, wire harness and throttle
cable routings for reassembly purposes.
HEADLIGHT POD ASSEMBLY
1. Install and electrical components removed form the
pod.
2. Reconnect all electrical components.
3. Route and refasten the wiring harnesses, vent lines,
and throttle cables as they were prior to disassembly.
4. Align the rear half of the pod with the mounting holes
and install the screws.
TORQUE
Pod Screws:
Until Fully Seated
5. Align the front half of the pod and install screws.
TORQUE
Pod Screws:
Until Fully Seated
BODY / FRAME
To Next Page
Loading...
