8
8.11
5. Refer to “Steering Exploded View (EPS Models)”.
See:
TORQUE
Upper Steering Post Pinch Bolts:
14 ft. lbs (19 Nm)
NOTE
Make sure to route all vent lines, wire harness and
throttle cable correctly into the lower headlight pod.
EPS UNIT REMOVAL
1. Remove the front rack or front storage box and front
cover.
2. Remove the right front wheel and shock assembly.
3. Remove both front mud guards, upper side panels,
front cab and right-hand footwell.
4. Remove the fuel tank.
5. Remove the pinch bolts retaining the upper steering
post to the power steering unit.
6. Disconnect the (2) electrical harnesses from the
power steering unit.
7. Remove the (2) fasteners retaining the upper
steering post bushing bracket.
8. Lift the upper steering post up from the power
steering unit.
9. Remove the lower steering post pinch bolt and nut.
10. Remove the mounting fasteners and nuts that retain
the power steering unit and mount plate to the frame.
11. Carefully lift the power steering unit up to disengage
the lower steering coupler and remove it from the
chassis.
STEERING / SUSPENSION
To Next Page
Loading...
