5
5.5
PVT SYSTEM SERVICE
PVT SEALING AND DUCTING
COMPONENTS
PVT DUCTING ASSEMBLY VIEW
REF.
DESCRIPTION NOTES
q
AIR INTAKE BOOTS
w
SCREW
e
CLUTCH DUCT BOOT
r
WORM DRIVE CLAMPS 14 in-lbs (1.6 Nm)
t
INNER CLUTCH COVER Apply RTV silicone sealant to the outside edge of the inner PVT
cover to ensure a water tight fit between the cover and the
transmission.
y
SCREW 7 ft-lbs (10 Nm)
u
CLUTCH COVER SEAL
i
OUTER CLUTCH COVER
o
O-RING
a
PLUG
s
SCREW 48 in-lbs (5.3 Nm)
PVT DISASSEMBLY
Some fasteners and procedures will vary. Refer to the
appropriate parts manual for proper fastener placement.
1. Remove the seat.
PVT SYSTEM
To Next Page
Loading...
