2.4
PRE-RIDE CHECKLIST
Failure to inspect and verify that the vehicle is in safe operating condition before operating increases the risk of an
accident. Always inspect the vehicle before each use to make sure it's in safe operating condition.
ITEM
REMARKS
Brake system/lever travel
Ensure proper operation
Brake Pads
Ensure sufficient brake pad matierial
Brake fluid
Ensure proper level
Auxiliary brake Ensure proper operation
Front suspension
Inspect, lubricate if necessary
Rear suspension
Inspect, lubricate if necessary
Steering Ensure free operation
Tires Inspect condition and pressure
Wheels/fasteners Inspect, ensure fastener tightness
Frame nuts, bolts, fasteners
Inspect, ensure tightness
Fuel and oil Ensure proper levels
Coolant level (if applicable)
Ensure proper level
Coolant hoses (if applicable) Inspect for leaks
Throttle Ensure proper operation
Indicator lights/switches
Ensure operation
Engine stop switch Ensure proper operation
Air filter, pre-filter
Inspect, clean
Air box sediment tube Drain deposits whenever visible
Headlamp
Check operation, apply POLARIS dielectric grease when
lamp is replaced
Brake light/taillight Check operation, apply POLARIS dielectric grease when
lamp is replaced
Heat Shields Inspect for damaged and are properly secured
Riding gear Wear approved helmet, goggles, and protective clothing
Winch (if equipped)
Inspect cable and switch
MAINTENANCE
To Next Page
Loading...
